Heat Insulation Board Plaster
High strength, adherent, fiber reinforced, ready to use polymer modified and cement based high performance shrinkage and non-cracking plaster used for plastering on polystyrene based insulation plates.
APPLICATION AREAS
Rockwool, extruded polystyrene (XPS) and expanded polystyrene (EPS) board plaster used indoor and outdoor areas
PRODUCT BENEFITS
Waterproof, non-impact and frost resistant and lightweight flexible structure that is included with polymers has a very goog adherence, it is economical.
TECHNICAL DATA
Powder Color: Gray
Pack: 25kg craft bags
Aplication Temperature: Minimum surface temperature +5 oC / + 35 oC
Pot Life: Approximately 60 minutes
Consumption: Depending on surface conditions, approximately 4-5 kg / m2 powder.
SURFACE PREPARATION
The surface of polystyrene plates should be considered to be clean and dry.
PREPARATION AND APPLICATION INFORMATIONS
TECHNO WORLD 6-7lt (air temperature may vary depending on variables) into a clean and cool mixture of water (25 kg) and low-speed powder poured into a mixer with the appropriate lump-free homogenous mix is achieved in 3-4 hours and 50-10 minutes to stand. Maturing material is ready for use again mixed. Powder into the water should not participate. Application temperature +5 to +35 oC is recommended.
Polystyrene materials prepared by the steel sheet surface is plaster mortar, and maurer, approximately 2mm thick plaster with mortar formed by the plaster will be corrected. After the expected. After applying the second coat plastering mortar, dry mortar to the surface is close to the sponge. Followed by coating the surface with the sponge is nade available to löse. After curing the surface in any desired color and appearance of coatings can be applied.
THOSE THAT SHOULD BE CONSIDERED
Approximately in two hours prepared material should be used. During the application the surface should be protected from wind and rain sun.
CLENING THE EQUIPMENT
With water, just after application
DISPOSAL
Dispose of empty pacaging according to local regulations or recycle. Collect waste material, allow to dry out and harden and then dispose as construction waste.
PACK
25kg craft bags
STORAGE
Shelf life – 6 months. Products in a cool, dry place to put conditions on top with a maximum of 8 bags stowed.